Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you very much .. brother.
However .. the problem is i have some broken ecu.
Need to replace it .. and i'm still trying to figure out how to read its firmware .. and clone it through an equivalent white ecu ..
good health.
Dear bros.
Please give me advice....
Which tool can read and write this microcontroller?
"R5F72544RBGV"
Please take a look at the image it can connect JTAG to?
Good health. respect !!!
Sir, the problem lies ... when i try to read and save the data in ic to a file ... then it informs me that:
INFO - Scanning USB Port EzUSB-0 ...
ERROR - Scan Failed - Creating Blank Programmer Project.
ERROR - Failed to Load LSC USB Driver. Make sure to select the right type cable.
If you have...
Hope someone has experience on this issue give me good advice.
It took me days to get to know and do it all .. but it was all in vain.
look forward to the help...
After completing the procedure and the Diamond Programmer informs me at the OutPut table as follows:
Lattice VM Drivers detected...
I make the power supply to the device
And ipsDownload Cable shows up green light.
The driver procedure has to follow the complete instructions.
However, in the control panel as shown, I was told that "Failed to load windows usb driver LSC"
I have tried two win 7 and win xp operating systems.
I...
I thought it was unprotected ...
As in the testing process, when ic lattice was running well on the main failure, it worked fine. The problem is just copy the data in it out .. to an equivalent white ic, the problem will be solved.
Need some help ...:idea:
Hello, good day.
Please take a moment to listen and give advice.
My problem is as follows:
As in the attached picture, I have a circuit board that uses ic lattice LC4064V, which is working fine.
And as in the picture, i have a similar circuit board, it is broken ic lattice LC4064V.
With...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.