Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Help me in P*otel
Thanks House_Cat. I am using Protel99SE and I would preferably use spacing not less than 0.5mm and not more than 1.0mm depending on my desing.
Hi everyone,
I have designed a PCB in Protel. It is a single sided board. After completing I placed a polygon as GND powerplane. As you can see in attachment there is very small clrearance between polygone edges and tracks/pads. I have tried my best to increase the distance but found no options...
If you want to detect only the maximum and minimum limit of your working arc then limit switch is the simplest way to acheive. If you want to keep a log of each position then you need rotary encoder. It is best to buy one but if not possible you cab build yourself a simple one. In any graphics...
I am Pakistani. I speak Urdu, Punjabi and English
Pakistan is the most beautiful part of land on glob. Punjab is the only province on this glob that has snowy mountains, rocky terrain, plain land, five rivers and one desert in the same province :cry:
PAKISTAN ZINDABAD
LONGLIVE PAKISTAN
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
