Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello guys,
i'm trying to know how to make the electornic circuit for the control of a stepper motor......i knew that a ULN2003 is limited to 0.5 A ......but my motor is about 3 A.....so i don't know what circuit should be used or designed.....anyone can help.........there are drivers available...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
