Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
30 ma needs a 167 ohms resistor to give the around 5V needed for ADC, if that is a high resistor to be inserted in the circuit, then you will select a smaller one and use an amplifier, select a very low input bias current and input offset current to minimize the error due to its currents at 1 ua...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
