Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I want to built this project Digital PWM controll,picture attached, but i have problem to
find pic12f508 in my town I have pic12f629 and in discription for building this project they
say that with minor reduction on code can work with pic12f629.
So guys please someone to convert the code for...
Hello
i try to programm atmega8 with this avr programmerhttps://electronics-diy.com/avr_programmer.php but when I try to open a hex file I recieve note
'' File not found'' below is picture.
I check all parts and there are ok,finaly I check my PIC16F628 and I can read and write on him but anyway I buy a new one and gues what finaly it worked out,I calibrated by first mhetod,I measure the dc voltages when the charger is on,with batery in and without PIC insade,on pin 17 I adjust the...
Hello Dexter
I try again this metod by measuring the dc on charger out and my bateries are 2.8volts,so on pin 17 should get 1.35 volts but I get no more than 0.4 volts on pin 17(Adjusting with pot),I do it this test with PIC out of charger,and I check all components they are OK,can you post once...
I measure the dc voltage on charger output it is 2.85V,and with adjusting the pot(I have multyturn pot of 2kohm,on pin 17 I get between 0.19 and 0.25 volts.
Please help,I realy want this charger to work
Regards maco bt
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.