Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
[solved]
After studying several schematics, I had decided to make a add-on board of ICSP circuit using tristate buffers 74HC125 & 126. (Poyto rev.C) Today I've just made PCB and hooked to ICD2 clone. Now the debugger (at least CCS) works!
love
Hi all,
I know ICD2 is obsolete and we can buy ICD3 at less than $200 now. BTW, I needed to debug my code on 16F1827 and most of parts were on hand, I had decided to build a ICD2 clone and a 8.5V Vpp limitter. (poyoto rev.B?, using transistors) It took a few days from etching PCB to soldering...
Hi
MPLABX doesn't support ICD2 anymore. So use MPLAB last version (v8.92) that contains vista/win7 64bit driver for ICD2.
As for compiler, Hi-tec is merged into XC, so I guess you better use XC8. (I use CCS-C tho.)
love
The problem solved .... again Prog_delay.
Auto_adjust value was 2, I have changed to 4 as help says, it looked working, but not. I have changed to 40 , now it works....
Hello, I am new to this forum.
I have built P16Pro hardware, and trying to program 16F628. After adjusting Prog_dealy on version 014 of PICALLW, it seemed working. ( I needed to pull down PGM pin. ) Then later, I made a small test program using CSS C Compiler, and write to PIC. When the chip is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
