Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Guys
I have a simple question and i am not getting this. What is the purpose of this 10k Resistor parallel with opto-coupler. Both goes into an Tri State Driver IC (AD244)
Thanks
Hi guys
i have a simple circuit of opamp which gives 1.65v output on 3.3v input (copied from somewhere). I wanna know what is the purpose of 100Ω resistor and a capacitor? Is it for filtration or current limiting? following is my circuit
Thanks
who said you i want to open .png file in it. I will draw the circuit in circuit maker and want to add some more circuitry. I am using Orcad for that purpose but not find it user friendly. That's why i want to install circuitmaker to see whether its user friendly or not
Thanks guys for your suggestions
when i install the software it ask me to install here, as in the attached file. Should i continue it or change the location?
thanks
Hi guys
i have downloaded the circuitmaker and installed it but i am getting error
How to remove that. I have the latest version of .NET installed
Thanks and best regards
Hi guys
in a program i am unable to understand a function. Kindly help me to understand how it is working?
in a program at some point a function is called
PIT_SetupCallBack(Pit0CallBack);
void PIT_SetupCallBack( T_PIT_Callback CallBack )
{
PIT_Callback[0] = CallBack;
}
Pit0CallBack will...
Re: want to define a single macro.Is it possible?
why are state and pin for?
they should be same.it represent logic level HIGH or LOW
your function also uses the 2 macros.
Hi guys
I am using ARM controller and want to change the state of pin ( 0 or 1) which i assigned as OUTPUT.
The port output register in arm is GPIOx_PDOR which is 32bit.
where x is port A,B,C..etc
i have made a macro like
#define DATA(x) GPIOB_PDOR |= (x<<2) & 0xFFFFFFFF
initially i high...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.