Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi guys!
As you can see in the attached picture, I have two waveports and these are the red and green one. The red one is fine but when I try to assign waveport to my WR I get the following error:
Port refinement, process hf3d error: Port 2 does not have a solved inside material on either...
Hello everyone!
I'm currently working on a bachelor thesis, where I am going to design Microstrip-To-Waveguide transition. Right now I'm working with a rectangular waveguide - WR12. However, as seen in the pictures that I've posted, the microstrip consists of 2 WR, one on the upper side and...
Hi guys!
I'm new to HFSS programming. I'm asked to design rectangular waveguide as a type of WR-12. I have following parameters such as width (a = 3.1 mm) , height (b = 1.55 mm) and cut-off freq (f = 48.3 GHz). My question is that how am I suppost to calculate the thickness of my waveguide? I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
