Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The search button on this site will get you off to a good start.
Why the PIC18F452 its obsolete, If I where starting with the Microchip range today I would use the 16F range as there is just so much good material around. Its then a small step up to the 18f etc.
There is a very good 16F guide...
max232 atmega db9
I’m not sure with the Ericson but most Mobile serial interfaces are 3.3 Volts so you may not need the MAX 232. The MAX232 translates [PC +- 12volt] to uC 5volts. If your ATmega32 is running at 3.3 Volts then you should be able to connect with just a couple of current limiting...
Embedded In The Blueroom:
µC Solutions in the Blueroom:
Embedding The Microchip PIC: *Microchip PIC used in context*
Plus a descriptive sub title: A guide to the Microchip PIC etc.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
