Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi All,
I am using expedition PCB 2007.9.2 with DX designer .
I have layout only and I wanna create a new library . I got part and cell hkp from layout. But i need to part symbol also.
Is there any possible to get part symbol from layout database.If yes Please share me the detail to get the...
Hello all,
I am new in allegro tool. Is there any option to find dangling vias in allegro as same like in expedition pcb?
I need urgently..Any body please help to solve the problem
Thanks in advance ,
Logiks
Hi All,
I'm using expedition pcb 7.9 version with dx designer.
I don't have library but i need to add few parts in both sch and library.
I have imported cell and parts ASCII from layout into library.I don't have option to import the symbols.
Can any one share if any option to exoprting the...
I am using expedition pcb 2007.9 version.I am unable to read the ascii files which generated by inbuild tool. Can any one help me to get readable format.
I am also tried in build dataconverter .exe but not working. Please help me.
Thanks in advance
Logiks
Hi All,
I got solution for this .Please follow as mentiined below
In CES go to -->setup-->settings-->Poweand grounds tab. Now you can modify the netclass and enable the visible mode.
Once done this net visible under nets tab.
thanks,
Logiks
Hi All,
I am using expedition 2007.9 cad tool with using CES.
In both layout and schematic (Ex:+3V3) net is available ,but not loaded one particular net in constraint editor.Except one net all nets loaded in CES.
I never came acroos this issue before.
Could any one please reply me to solve...
Hi All,
I am new in expedition 2007.9 version.
I am unable to execute xtream desion session in this version. when I open this session needs RSCM and get closed files.
Could anyone help me to use this option in 2007.9 version as same like 2005.3
Thanks in advance
Logiks
Thanks for your response.
Now I have board station file and viewer only.
i want to know how does open board station file in expedition pcb.
Please help me.
Again thank you so much for your support.
Thanks,
Logiks
Hi ,
In expedition go to place mode ,select parts (which is you want to move ) and use F5 (Push parts) in keyboard.
Now parts moved to bottom layer but make sure your that part orientation because opposite side get mirrored.
If you want you will rotate.
Thanks
Logiks
Re: How to import board station cell.hkp to expedition libra
Hi Eda
I am new in board station and I have RE viewer only .
Is it possible to define variable in RE viewer and where is I need to place.
Please explain this is very very urgent me...
I am looking forward to receive the reply...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
