Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Klaus and Dick,
Thank you for the feedback.
I have tried to read the datasheet, but mostly it is incomplete.
Some datasheet only shows the operating temperature, not the reflow temperature, that is why I find it is so difficult to get any information.
For the internet research, I have done...
I am planning to use a lower temperature solder for the SMT process (still not sure how low is it, but probably less than 180 degree celcius)
Saying so, I am wondering if we can put the through hole (TH) component inside the SMT reflow machine.
Is there anyone have any information about this...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
