Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi!
What dimensions should have a port for a 50Ohm microstripline (1.1mm width and 8mm length) on a 0.5mm thick Rogers 4003 substrate (Er=3.55, tandelta=0.0027) for CST time dom. simulation for freq 0-40 GHz? It is something wrong width my s21 insertion loss - much more than that of the same...
te mode tm mode cst
Hi!
What dimensions should have a port for a 50Ohm microstripline (1.1mm width) on a 0.5mm thick Rogers 4003 substrate (Er=3.55, tandelta=0.0027) for CST time dom. simulation for freq 0-40 GHz? It is something wrong width my s21 insertion loss - much more than that of the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
