Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am trying to build a RTC to be used within my temperature controller project and need a PIC assembly code that reads and writes from the DS1307 RTC chip.I am using the PIC16F877 which has seriall data and clock pins..but dont have a clue on how to go about it.PLEASE help me...
thanks
pic16f877 counter
I have a simple question. How would I configure the TMR0 of the PIC16F877 to run on an external clock (32.786kHz). eventhough the chip will be running at 4MHz?or maybe even if it runs on the internal instruction clock cycle?how do i get the timer0 to produce an interrupt every...
question on PIC header
Does anyone know what effect _config 0x3D18 has on the programmer?
I downloaded a code with this header and when i change it,the code doesn not work on the Microcontroller.what exactly does it mean?
concept of lcd interfacing with pic16f877
hi there!I am despeartely in need of an assembly code to interface and write characters/strings out to a 16x2 LCD module with the PIC16f877 microcontroller.
PLEASE HELP ME!
thanks
thermostamp.html
hi there!
I have been assigned a project whereby I have to
design a microcontroller based controller for a
domestic geyser/water heater.
basically the requirements of the controller is for
the user to be able to key in desired temp and on/off
times for the geyser.there should...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.