Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Sir, I want to simulate one bow tie antenna with lumped source. I want to add noise to the source of the antenna that means changing setting as with this procedure: HFSS> design properties> click statistics> click distribution column> .... then after this I am unable to under stand what to do...
I need help to correct HFSS. When I start simulation, it gives message :
(1)Adaptive solution setup, process hf3d error: Matrix solver exception: out of memory, please verify Desired/Maximum RAM Limit setting
(2)Simulation completed with execution error on server: Local Machine.
I do not know...
Friends, I need a favor of you, for designing a project to plot RCS v/s time of a conducting body with HFSS 14.0 Transient model. EM waves are being radiated by patch antenna. I want to know the procedure to make this model. If you know/ have any solution, please share with me urgently.
Hi Friends, please help me.
I have designed a bow-tie antenna as with dimensions given in pic also. Dims are given as below;
bow tie one arm: arm length=4.1cm, outer width=2cm, inner width=0.25cm
Gap width=0.25 cm
Sub= Width=10 cm, Length= 15 cm, height=62mil, permittivity=2.2
But I am getting...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.