Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
Me and other people of engineers are designing autonomous robot that should be able to navigate through gps waypoints. I'm looking for GPS module that is able to store waypoint data.
Can you please suggest a good module? I'm looking into sparkfun.com
Thanks
Hi,
I'm an undergraduate student studying electrical engineering. Right now am taking a DSP course and the college is providing us with "Digital Signal Processing: A computer-based approach" by Sanjit Mitra. I'm not sure if this book is good or not. if it is not good, can you please tell me a...
Thanks, for the clarifications. I've the changed the values according to fg, now it is working :)
Kz9
Added after 2 hours 9 minutes:
On thing else, I connected a germanium diode AA112 at collector and measured the voltage, I am getting 12v from 5v supply, but when I connect the diode in the...
If I connected an LED to the output, would it light up? or it will damp the oscillations?
or is there a better way to know that it is oscillating?.
I don't have an oscilloscope to observe the oscillations.
Kz9
Hello everyone,
I am trying to desgin RF oscillator.
I have 3904 transistors & 6.8uH inductors & lots of resistors & 100nF capacitors.
I tried to desgin it on Multism , it worked, I get sine wave oscillations.
however, when i try to do the real thing, it doesn't oscillate.
i'll attach sketch...
It worked, thanks man :)
If am not asking too much, can you please explain how does it work and why is it different from the pierce desgin, the one with inverter.
one thing also, I used 1.1k Ohm resistors instead of the 470's. cause I didn't have any.
thanks again. :)
Hello,
I have a crystal quartz 3.57945 MHZ and a HD74LS00P Quadruple NAND gates, with 2 70pF variable capacitors & bunch of resistors.
I want to desgin a sqaure wave oscillator using these components, but I don't know how, I've tried the pierce oscillator desgin...but I can't get it to work...
Hello everyone,
I want to desgin a device that communicates with the computer via the USB port. more like a "hello world" project.
I know I need a microcontroller; but is it any microcontroller that just need some code written to it, or it must has a USB interface?
And about the D+ and D-...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.