Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Port Communication Protocol is some data command to change or realise module's parameter setting. You do not need to set the ID, just tell you requirments to the modules provider. They will set ID for the modules before delivery and give you the command.
About TX, RX selection, there are some...
Hello,
1. For wireless remote control, there is usually a transmitter connecting to the device and then a receiver connecting to the terminal, usually a PC or MCU. This is point-to -point transmission. The transmitter and the receiver is just to instead the previous RS-232 or RS-485 Wired...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
