Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dynamic Biasing
I would like to design a dynamic biasing of VCC, depending on the input signal of Power Amplifier. Pls suggest me which topology should l use to control the VCC of main PA.
Dear,
Please suggest me in Design of Power Amp
Specifications
Bandwidth 10.5Ghz ~ 11.5 GHz
Output power at 1db compression point 5W
Gain - 30dBm at 1 db compression
Gain Flatness 2dBm
Pls suggest me about it
Thanks
Pls,
I want to design two-port amp.
Tx of 1mW at port 1 is amplified to 1 W at port 2 (Rx).
Rx is supplied at port 2 and amplified to 40dB at port 1 with less noise.
Freq 1.8 to 2 GHz
Ref Impedance 50 ohm
Supply Volt 3 V.
I need reference to design above specification.
Pls advice ...
Pls,
I want to design two-port amp.
Tx of 1mW at port 1 is amplified to 1 W at port 2.
Rx is supplied at port 2 and amplified to 40dB at port 1 with less noise.
Freq 1.8 to 2 GHz
Ref Impedance 50 ohm
Supply Volt 3 V.
I need reference to design above specification.
Pls advice ...
Hi All,
I'm a student specialized communication.I want to know about signal propagation in wirless communication.Especially in signal lost due to reflection, diffraction and scattering of signals.Pls guide me.
KMT
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
