Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
This question is related to tetramax tool (run_atpg)
1)after running "run_atpg"(command) :test_coverage is 100% and it gave 36 patterns
then I saved that patterns using the "report_patterns" command in file_1 then I wanted to write that patterns in STL format
2)I used Write_patterns...
Hello,
This is a STIL file generated by TETRAMAX.
can someone explain why there is a "P" at starting of the pattern in some "_pi" patterns for example in lines 257 and 261 there is a "P" but in lines 265 and 273 it's not there?
thanks,
Venkat.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
