Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hey,
I was wondering how to design a differential PA, so basically you have two common source amplifiers which are connected to a transformer with a center tap.
How do you do load pull on a differential pair to know the optimum load impedance for the transistor? Do you just use one single...
Hey,
In the PDK that I am using the sheet resistance of the metal layers is in Ohm/sq, does anyone know what this sq means and more importantly how to converter this unit to Siemens/m. I need Siemens/m for ADS metal stack definition.
Vcc= 3.3v
Black square wave is the input, and i want to mirror that over the 1.65v horizontal line so i get the green square wave.
Does anyone have an idea of how u could do that ??
I have converted Pulse width into an amplitude(that is what u see there, the max always occurs on the falling edge of that PWM). So getting the minimum peak will give me the smallest pulse width. I've thought about use a CMOS latch storing those peaks and then using a comperator to find out what...
I need to detect the minimum peak of a sawtooth signal and output it. Does anyone have an idea how i could do that?
EDIT:Maybe i should clarify, using CMOS circuit design.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
