Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by kumarpradeep

  1. K

    Multilayer-inductor-parameter measurement with VNA

    Re: Multilayer inductor parameter measurement with VNA First,we need to Understand what types of amplifier measurements are made with RF VNAs. • S-parameter / Stability factor (K-factor) • Measurements with power leveling • Gain compression (P1dB compression point) • Pulsed-RF measurements •...
  2. K

    Please help and comment on my common mode choke circuit.

    A choke is a power magnetic component which is used in electronic circuits. It is an inductor that is utilized to block high-frequency, alternating current (AC) in a circuit while allowing lower frequencies, or direct current (DC), through. The choke normally consists of insulated wire that is...
  3. K

    What is the difference between SMPS regulator and LDO regulator?

    Linear regulators are a great choice for powering very low powered devices or applications where the difference between the input and output is small. Switching regulators on the other hand are highly efficient and available as modular chips which are compact and reliable.
  4. K

    Transformer for DC\DC converter for Automotive Application

    Choosing the right DC-DC converter for automotive applications can be a challenging task when one considers all the requirements that need to be met. Power management in automobiles has come a long way from being the ubiquitous load-dump-protected 5V linear regulator. Power Transformers in...
  5. K

    Ignition Transformer Design

    An automotive ignition coil does not work on the principle of a transformer as such... the turns ratio is only 100 to 1, so 10 volts ac in gives roughly 1KVolt out (usually much less).
  6. K

    [SOLVED] High Voltage AC to low voltage DC

    The current you need is low, you could wind your own coil and tap power by placing it within the magnetic field of the overhead line. You may not have to get too close to the 10KV line (that depends on how much current is passing down the 10KV line and consequently the magnetic field strength).

Part and Inventory Search

Back
Top