Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello Manjunath,
i have attached the Schematic .Please see to it.
Please tell me how to simulate the schematic in MWO or ADS with voltage sources .
Thanks
Hello Manjunath,
Yes,Power divider went quite well.Thanks for your help.
I am planning to use MACOM PIN diode switches in series-shunt combination(involving quarter wave transmission lines)
Please guide me regarding the usage of Spice models.
I am not having the Schematic but will post it...
thanks a lot for your help
you have cleared many doubts of mine ...
Added after 4 hours 31 minutes:
now that i have simulated and my schematic and EM simulation are matching ,can i go for the manufacturing of the power divider ?
whether the Thin film resistor with resistivity 50 ohm/sq is...
Hello Sir ,
Thanks a lot for your help .The file that you have attached is unable to open in my AWR .But i have done the changes and results are satisfactory.
It will be greatly helpful if you attach the snapshots of settings of enclosure and resistor.
And if i am satisfied with EM simulation...
i have aatached all files for Schematic and EM .I had exported the layout in gds format and then used that format to link it to EM structure .later I defined copper layer with conductivity ,thickness and substrate layer with all specifications.
I had efined resistor also (blue color)...with 50...
Thanks Manju for your reply
But I am having problem in Em simulation .If I am trying to copy the layout (derived from schematic and pasting it in Em enclosure it is not fitting exactly into it. hence i cant add ports to it .Snapping the structure causes the layout to change .
can you please...
I have simulated a 2 section wilkinson power divider at 2-4 GHz using lumped resistors in schematic of AWR .Since layout is not reflecting that resistors ,I can't do EM simulation .Please suggest how do to this and to take care of the parasitic at higher frequencies
I have to connect a 10 V DC to an amplifier working at 18 GHz .can you suggest me the correct copper wire to be used ,with the thickness and alloy?
Thanks ......
I have to select capacitors for bypass and dc blocking applications for 20 GHz range .
can anyone tell me the necessary parameters to be considered while its selection ?
thanks
how to design a variable local oscillator in mixer(down converter) depending on the input RF frequency
RF 2-18 GHz
LO-1-13GHz
IF- 1-5 GHz
thnks in advance
i have designed a 2-18 GHz wilkinson power divider-2 way.
can anyone plz tell me about the procedure to obtain the power handling capacity in simulation ,preferably in AWR.
thnks in advance.
Can any one tell me the design for the 3 dB , 1-18.0 GHz directional coupler .
which directional coupler out of coupled microstrip line ,lange coupler and branch line coupler can be used to realise it ?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.