Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Ah yes - I see. Actually I had some space left on the board so I have now fitted in the footprint of one of the Samtec connectors and made all the traces to the pads. I think I will build in some protection on the programmer board. What is the best way to assure that in- and outputs are not...
Thanks for the link Alex. Yes I've seen quite a few test clips for DIP and SOIC, but the packages I use are QFN24 and LGA12, which are only 4x4 and 3x3 mm. I've been looking for test clips for these packages, but I didn't find any - which I actually didn't quite expect either, as the size is so...
Thanks Keith. I will make a footprint for a spring loaded connector kind of solution, and the idea of flashing the devices before assembly might also come in handy. Actually a combination of these would be perfect I think. The chip is also available in OTP, but I'm a little scared of producing a...
I'm looking for some ideas on how to connect two boards in a small and cost effective connection. I will use a programmer board to flash two devices on a small 1x1 inch board, and the small board needs some form of connection for this one time flash procedure. I will have to program 1000+...
I need some advise on how to proceed from prototype to production.
I've made a prototype on the FEZ Cobra, and is now looking into bringing the costs down for a small scale production (100+ units).
The basic components are:
3 accelerometers, GPS module, TFT touch Display and the EMX board...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.