Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
pcb design pakistan
Hi,
We are PCB designers working in india having 5 to 6 years experience of doing PCB layout designs.We have sound knowledge in all the softwares.
We can assure to do the designs with good quality & also time delivery.
If you are intersted pls put a mail to...
right click select components - right click select all - again right click save to library-- the dialogue box 'll show all the decals & parts which are present in the current design u can select all those and save it into particular library...
I'm started to work in Dxdesigner.
I can't able to set the font type in project - settings - font.Always it is fixed type only.
And I can't able to set the visibility for the pin numbers globally..
Thanks in Advance....
Re: Rf Design
Hi,
U told to avoid the sharp corners.
What is the advantage for using the smooth corner traces?
Pls explain me more..I'm new for Rf layout design
Hi all,
I'm new for rf design.Is anybody have the documents for rf layout design guidelines.
What are the things need to be follow in component placement & routing.
And why don't we use the smooth curve traces instead of 135 deg.
Thanks in advance..
Hi,
Im new for Dxdesigner Schematic editor.
I have one problem in symbol creation...I want to create opamp with 2 parts in 1 symbol..
means opamp have 2 set of Inverters.So i would like to create it as a 2 parts.But i don't know how to create it
In padslogic, I have assigned it as a 2 gates...
I didn't get ur point..Pls explain me more..................pls
I'm new for circuit design...so i need a more information about how to choose the value of ferrite bead...
and
What is the advantage for using ferrite bead...
Thanks for ur reply..
Added after 10 minutes:
Ramesh,
you told that the purpose of 0 ohm resistor is to physically join.At the same time, ferrite bead produce some inductance...
And also we need to join both agnd & dgnd only...
Then why 'll choose ferrite bead instead of 0 ohm resistor
Hi,
We are using ferrite bead or 0 ohm resistor to join the AGND & DGND grounds in one place....
I would like to know which one is best...ferrite bead or 0 ohm resistor...
Pls help me
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
