Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by koshary

  1. K

    Testing a ferrite transformer

    Thank you very much for your help,helpful post i did click
  2. K

    Testing a ferrite transformer

    May i use a pulse generator followed by a power transformer /(transistor not transformer) May i use a pulse generator followed by a power transistor
  3. K

    Testing a ferrite transformer

    Thank you for your reply. First part about permeability OK i can understand that, L=Uo Ur n^2 A /l as Uo=4pi*10^-7 Ur=core permeability n=number of turns A= cross section area l=winding length So measuring L , knowing core dimensions ,n and l i can get Ur (ignoring wire resistance). But the...
  4. K

    Testing a ferrite transformer

    If you have a ferrite transformer and you know its dimensions but ferrite core type is unknown, what would you do to test it? It has no winding ,you will wind it !!
  5. K

    Identifying salvaged transformer

    I guess no one ever opened such a supply or it is a custom transformer !!!!
  6. K

    Identifying salvaged transformer

    Sorry ,here is the schematic
  7. K

    Identifying salvaged transformer

    The transformer is that used in an IDE psu 220 ac input, 12v 2A 5V 2A output. It is an EI ferrite transformer with a gap between the center leg of the E shaped part and the I part ,the center leg is cylindrical. Its dimensions and number of turns for each winding are known (i have...
  8. K

    Pulse duration measurement

    Thank you for your replies. If i use single timer,read its value at start of pulses assigned say x then read three values at the end of each pulse a,b,c hence durations will be a-x ,b-x ,c-x. OK how will be the compensation or actually what is it ? (i am a beginner) pulse duration is in order...
  9. K

    Pulse duration measurement

    How can i measure the duration of three pulses all start at the same time but each with different duration ?. In other words how can i make three counters each start at the same time and then scan for three bits of say portA made as inputs such that a LOW on certain bit will stop its...
  10. K

    three separate counters using pic

    thank you for your answers yes they are three separate counters ,actually all of them use the same start ,count variable but each should stop according to a different condition ,as if you were measuring time taken by three runners all of them started at the same time but each one will stop...
  11. K

    three separate counters using pic

    Is it possible to make three separate counters using pic?

Part and Inventory Search

Back
Top