Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You should increase "number of pulses" in transient solver settings in specials tab to decrease ripples on the results. But remember this, increasing "number of pulses" will increase solving time in transient solver. I had my problem just like yours and That's the answer for this.
I think you are working with transient solver? If that so, You should increase "number of pulses" in transient solver settings in specials tab to decrease ripples on the results. But remember this, increasing "number of pulses" will increase solving time in transient solver.
Hi,
Sorry for late answer.
In CST, When you set the probe in the enclosure or wherever you want to observe E or H field, You should look at the left side of the program screen and you can see Navigation tree. In navigation tree, there are results and other thing. You should check the "1D...
Thank you for your answer. Ok but I can't do it. I want to define these three different materials ( I don't know where to place those material values) . How can I define in CST?
I know how to define or how to enter material section but I don't know definition of complex definitions in CST?
For example, How can I define dielectric material or magnetic material?
I understand. I will search and learn what you said, thank you. So, what should I do to prevent that in CST frequency domain solver ? Can you help me, please?
Thank you for answering. I did all you have said and I have a problem. In transient solver, there is a huge oscillation on the results' plot and after, I tried to measure the E field in the frequency domain solver and I achieved more accurate and time effective results. When I measure the field...
Actually, I am working on a shielding enclosure and I am measuring electric field on some points, but my measurements -results include oscillations. How can I remove those oscillations and get good results?
By the way, I am using probe to get electric field measurements.
Hi all,
I am measuring the electric field in the closure box with aperture and using probe to achieve that. But I have a problem. When I use the probe for measurement, results are not accurate in transient solver. So, I changed the settings in the transient solver > Specials and I use the...
Hi all,
How can I create a polygon with CST (For example, pentagon, hexagon, heptagon vs vs) ?
- - - Updated - - -
I found it how to create. You can use cylinder of shapes with its segments option.
Hi,
I want to calculate and draw SE(Shielding Effectiveness) in middle of the rectangular enclosure with CST. How can i do that? Please help me.
Thank you.
Hi,
I want to draw to Reflection Coefficient vs angle of incidence in CST, but i can't find how to draw. Please help me.
Thanks.
Note : i want to simulate this example :
Hi, i am trying to create this structure, but i didn't. Someone can help me? How can i create this structure? when i create a box with a relative permittivity of 2.25, CST says : "Mesh is too dense or calculation domain may have zero volume".
Structure :
Thanks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
