Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks again! I have taken your advice steps and successfully made the target. When I run in Debug Mode under either Simulation or Stellaris ICDI, the expected text was unable to show on screen.
With reference to the demo video, the program is not required to select the CMSIS and the Device...
Thanks! I have modified as per your advice. Now UART.h is readable. However, the outcome is different.
I am also surprised why you did not have any errors from startup.h.
I re-attached the modified UART.h with the supporting files for your reference.
Could you also share your setting in Options...
I had attached the screen-shot file in my former thread to indicate an UART.h has been linked into the sources group.
However, it was still not read by the C program.
I am beginner to learn TM4C123G LaunchPad. I have managed to build the first project of blinking LED through Keil5.
I tried to run another problem to calculate the area of square and print the result into the UART by simulation function of Keil5.
However, I could not build the target.
Is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
