Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Recently my multimeter, model DT9205P, burned out
But instead of buying a new one, I would like to repair it,
but the damaged U3 element (marked in the picture) has a burnt hole, so it is impossible to read anything from it.
Does anyone have a similar multimeter and could tell me what to solder...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
