Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Sorry I don't quite understand how MPLAB can change the PICs configuration after it's been programmed. What is done in MPLAB (after the code has been loaded onto the PIC) to actually force the configuration changes onto the PIC?
So just to clarify, if the Configuration Bit is set under the Configure menu in MPLAB, the associated Configuration settings will override whatever had been set in the code?
Thanks again for all the quick replies and suggestions. It's definately a 20MHz external xtal and here are the Configuration Bits set under Configure in MPLAB v8.15a ("Configuration Bit is set in code" is checked):-
Address
Value
Category
Setting
2007
FFB2
Oscillator
HS...
Thanks for the suggestion guys. I moved it out of the loop and into the main, still no luck :(. I even tried it out of the main, but errored while compiling.
So not it looks like:-
//(c)Shane Tolmie, http://www.microchipc.com/, distribute freely for non commercial use on the condition that you...
Hi,
I'm hoping this is something simple, I've been at it most evenings this week and I'm slowly going insane.
I just got back into pic programming (well trying to) after a few years and I'm failing epicly.
I'm using a PICkit 2 and a dev boeard I made a while ago that holds a 16f877a and is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
