Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I use PWM on Msc-51.
But i can't Control Frequency.
I want 20Khz
CCON DATA 0XD8
CMOD DATA 0XD9
CCAPM2 DATA 0XDC
CL DATA 0XE9
CH DATA 0XF9
CCAP2L DATA 0XEC
CCAP2H DATA 0XFC
CF BIT CCON.7
CR BIT...
You mean ir2110 don't work with pic but i just use transistors / logic level drivers (eg TC427)
Could you draw diagram using transistors or tc 427?
And Don't have any way to use ir2110?
Thank
I can't build picture
I follow this picture all
But I don't connect pin10(Hin) pin7(Ho) and don't put upper mosfet
Pin2(Com) connect the G of mosfet
last pin5(Vs) don't conect the D of mosfet
Vin for Ir2113 12Vdc
Vin for My boost 12Vdc
When i On the Supply it's disconnect and overload...
I try to connect Boost converter long time.
and i find the way to use IR2113 Low side only
When i connect it! OverLoad All time
Any One Could Help me,Plz
Thank
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
