Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Sorry for my carelessness!
But I edited the file of model description like this for each model:
inline subckt ln121_hicum (3 2 1 9)
ln121_hicum (3 2 1 9) mdn_hicum trise=temprise ( replace for "q 3 2 1 9 mdn_hicum trise=temprise")
ends ln121_hicum
But the result is unchanged. I think we cannot...
I have already tried to replace subckt into inline subckt like your advice but it still didn't work.
I took another subckt in the PDK "nfet" and did simulation. The result is OK like the picture below. And in the model description of nfet,
it just have "subckt", not " inline subckt".
So I...
So I just replace subckt to inline subckt in this file like the previous time.
But it didn't work like i told you.
I still don't understand why we insert "inline"?
Thank you.
I changed all subckt to inline subckt in the model description as you said and
then I tried to edit_component display and i choose the component on the schematic
like the picture I attached. As result, it still didn't work as expected.
In the PDK, only this npn device have this problem. I did...
This is about the security problem. So I can just show you some lines of the model description below:
subckt ln122_hicum (3 2 1 9)
parameters temprise=0 l=10.16e-6 postlayout=0 rth_flag=0
*.PARAM
+ rth_flag_final = min( rth_flag+rth_flag_global, 1)
+ eml = l*1e6
+ el = l*1e6
+ ef = 1
+ emw =...
Here is the CDF of cell in 3 mode: effective, user, base
I tried to change CDF of cell or lib many times, but it still didn't work.
Actually I want to know everything about BJT like ic, ie, vbe, vce, ft,... through the print command in
analog environment.
But just show some typical...
Hi everybody,
I do simulation on cadence IC5.1.4.1 with PDK BiCMOS 180nm but when I want to see the operating point of bjt,
it shows me like this:
Can anybody help me to solve this error?
Thank you very much.
Hi everyone,
I am Kim. I am currently doing a project related USB Type C and I want to ask all of you about the operation of USB type C, especially about what kind of signal in each pin of USB type C :thinker: . For example, in TX/RX pins, which signal is used, pulse, sin, dc or ac... the same...
Hi BigBoss,
I'm Kim. I am a student want to learn about bipolar characteristics. I want to ask you about your simulation to measure ft. I do under your instructions but i can not plot the small signal current gain in the ac condition to find fT. And then, I also can not plot fT vs Ic. So can...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.