Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello people,
I need to use an Intelligent Power Module (IPM) in my project (3-phase induction motor inverter), but I haven't used it before. Thus, I need your advice about the good brands that manufacture these modules because they are not available in my country and I am going to buy it...
Thanks for your reply Easy peasy
If the wiring is flakey, could that cause this problem many times?
Thanks for your reply AdamsN
This happens in an open circuit situation without any load. The circuit works well, the problem happens when I touched it.
Thanks c_mitra for your reply
OK I...
Thanks c_mitra for your reply.
The circuit works well and I switched it OFF and ON again many times without any problem. Then as I said I touched the IR2110 with my finger, after that I found this problem.
Note:In every time I switched it ON, I let it running for about 20 minutes without...
Thanks for your reply.
If the wiring is flakey, may it cause this problem many times??
- - - Updated - - -
Thanks AdamsN for your reply.
This happens in an open circuit situation without any load.
Hello,
I am implementing a half-bridge converter as shown in the figure.
The problem is that the low side channel has been blown many times (LO pin becomes short-circuited with VCC pin). The circuit works properly without problems at first, but when I stopped it and touched the IR2110 for...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
