Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear everyone
I have simulate a simple EBG structure, single layer mushroom-liked EBG structure, as in attachment. However, I cannot get the same result as shown in Fig. 3 in the paper. What's wrong with my simulation, please help me!!!
Thanks for reply and sorry for the version. I have changed the version to v.11.
The transmission is about 7.3GHz. However, the paper is about 7.46GHz.
I am wondering what cause the error.
Dear everyone
I have simulate a simple EBG structure, single layer mushroom-liked EBG structure, as in attachment. However, I cannot get the same result as shown in Fig. 3 in the paper. What's wrong with my simulation, please help me!!!
THX!
Dear everyone
I have simulate a simple EBG structure, single layer mushroom-liked EBG structure, as in attachment. However, I cannot get the same result as shown in Fig. 3 in the paper. What's wrong with my simulation, please help me!!!
THX!
Dear everyone
I am looking for Microstrip antenna: Theory and design by James J. R., P.S. Hall
Can anyone help me
here is my e-mail: kevggion@yahoo.com.tw
Thank you
onmi directional antenna*
Hi everyone
I have faced a problem that the directivity of simulated antenna, half-wavelength slot antenna, is lower than 1 (an omni-directional dipole antenna ususally get 1.6 approximately ). Can any of you help me to figure out the problem.
Thanks so much.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
