Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi everybody,
Now, I'm doing a project relating to simulation of underwater communication system. The method using to communicate is MIMO-OFDM. Can you help me about:
1. The parameters of the system
2. Matlab file to simulate
Thank you very much
Hi umair67,
Can you help me to design a band pass filter using ADS and microstrip technology. The parameters of the band pass filter are:
1. Center frequency: 1.575GHz
2. BW=50MHz
and the following is parameters of the substrate:
1. εr=4.7
2. H=1.59 mm
3. T=0.35 mm
4. Tand=0.02
In addition...
Hi everybody.
I'm a new member of this forum. Can you help me to design a bandpass filter using ADS and microstrip technology. The parameters of the bandpass filter are:
1. Center frequency: 1.575GHz
2. Bandwith: 50MHz
and the following is parameters of the substrate:
3. εr=4.7
4. H=1.59mm...
Hi everybody.
I'm a new member of this forum. Can you help me to design a bandpass filter using ADS and microstrip technology. The parameters of the bandpass filter are:
1. Center frequency: 1.575GHz
2. Bandwith: 50MHz
and the following is parameters of the substrate:
3. εr=4.7
4. H=1.59mm...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
