Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,
I have a question about requesting S11 parameter in FEKO. I'm modeling a horn antenna, and I would like to "measure" the mismatch between the antenna's aperture and the air.
How could I do that?
Thank you in advance!
Dear all,
Firstly, I cannot divide it into three strips. May I use split command? Unfortunately, PIFA disappears after this...
Secondly, I have an error when I move port1 from antenna_feed to antenna_short or antenna_short2 after division...
Could anyone help?..
Dear dragonhamada,
I have PIFA antenna here File Upload - 128. According to my synthesis project I have to divide this construction and add two more ports for each strip. Therefore I cannot set terminals for those ports...
Yours,
Kate
Dear all,
I've got an error while using HFSS. I want to divide my construction and add one more port. During this process I've got "Port 'p2': The port has no terminals defined on it".
Best regards,
Kate
---------- Post added at 10:45 ---------- Previous post was at 10:44 ----------
I want to...
I have the same error... "The port has no terminals defined on it". Could you help me to understand this problem?
---------- Post added at 10:27 ---------- Previous post was at 10:26 ----------
I want to divide my construction and add one more port.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
