Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
None of the items are highlighted. Please write the caption (text) of the desired item, do not write non-obvious answers such as first one, last one, highlighted one, ...
Hi all,
As we know we may want to route a track with a width of high mils (60 mils). but some where it is needed that the track width is changed so that complete routing be possible. e.g. when it is needed to route the track between two pads of an IC. in this case we need the track width to be...
Hi all,
I use Layout Plus 10.3.0. in some cases we need to have a track that has a wide width (e.g. 60 mils for VCC or GND). but we may have components that have low pad spacing such as SMD ICs. if we want to route these tracks to these components, we may route the track with wide width (60...
Hello,
I am Using Layout Plus 10.3.0 that contains Allegro 15.2.1, when i use menu item Auto>Autoroute SPECCTRA>Launch SPECCTRA, it is shown a window that contains alist of products and asks me to select one. i have attached this window.
which of these products i should select to have muximum...
thanks,
but i which of them we can design a un-metalized 2 layer board? in many products if we use metalized 2 layer board, the PCB costs will be very higher than if we use unmetalized one and use resistor pads instead of vias.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
