Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, maybe simple, but programable 868MHz remote controler can be usefull for someone.
There is:
https://doitwireless.com/2014/05/26/remote-controller-with-pca9535/
And remote controled relay board
https://doitwireless.com/2014/04/10/iqrf-relay-board//
Enjoy and do not hesitate to ask.
Please could you someone help me with power suplies ICs recognition?
The first is in 3x3 SMD package with legs under package.
It has marking AMST L216 on top of package.
The second is in 2,6x2,6 SMD package, same legs
It has marking ANQS L204.
Legs are mainly on left and right side of...
BDRU Marking on SOT23-5
Helo,
I found BDRU Marking sign on some IC which is in SOT23-5, but I am unable to find datasheet for this device. Could you help me please?
Thank you for your time.
Altium Netlist template
Hello, I am newbee in circuit simulation, and I have one small question,
when I am using TI component 7400 and I link SN74F00.mdl as model, this file is linked to fast.scb. My question is, where I found Netlist template and correct pin mapping for this device?
Thank you...
Hi,
I'am using GC5016 as DDC, a I want measure the power level. All works fine, but the measuring is not running. I readed some tips from datasheet:
Example using a read of the msb to fire one shot:
1. Sync integration counter
2. Wait for ready bit to be 1 (8 clocks or less depending on sync...
as 4360 versao portugues
I use this circuit, interval VCO, no amplifier in loop. When i make short Vtune to ground, I am not able measure any frequency, co I think, that VCO is not running. I tryed route R counter output to test pin, so I measure correct 500kHz, but When I routed N counter...
4360 lock
Hi, I have problem witch adf4360-6 too. I have 26MHz reference clock. R-counter is set to 52 (I try get R-counter output on scope and 500 is there - this i right). but I have B counter set to 287 and A counter to 0 and RF out is on 3,3V still. I think, that VCO is no running.
My...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.