Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello everybody,
I have a specific question to the following challenge:
There are seven resistors (R1, R2, ... , R7) which have one common node. Now I cut through those resistors depending on the desired binary code, e.g. when I cut the resistor R2 and R3 I get the following binary code...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
