Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear PlanarMetamaterials,
Thanks again for your reply. I will try your idea of using the fields calculator.
The SAR plot I have attached is actually the Average SAR plot. In EMPro, actually along with this kind of plot the Average SAR for the whole volume can also be measured using which we...
Hello PlanarMetamaterials,
Thank you so much for your reply. I have moved to HFSS since I can measure the SAR value using FEM itself in HFSS. I have finished the design. I have finished the simulation also.
Now, I am not aware of the method to find the finite value of the Average SAR from the...
Hello all,
I want to know whether there will be difference between results if I use different methods(FEm and FDTD) to solve a particular design (antenna, surface coil etc) in terms of S-parameter and SAR.
I have used ADS for design a surface type coil and again used EMPro for measuring the...
Hello all,
I am new to HFSS and I am not familiar with the settings I have to do for SAR measurement. I have finished my surface coil design and got the S-parameter now I need to use the frequency of 63.87 MHz as the solution frequency to obtain the SAR inside a phantom which I have placed...
Hello all,
I am new to HFSS and I am designing Stepped Impedance Resonator(SIR) in HFSS 15. I have followed a tutorial pdf from Internet(only to know the design steps which does not have the steps to design SIR ) to complete the design in HFSS but during the simulation I am getting the error as...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.