Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
No AT32UC3C2128C is not an Arduino compatible microcontroller. If you are looking to work on a 32-bit platform consider using mbed,**broken link removed** or Chipkit
If your looking for an 8-bit microocntroller go for Arduino,**broken link removed** or Wiring boards.
I have a unipolar stpp Motor which is rated at 22V for appropriate operation....I have to use it in an application requiring high torque....which is only possible at and above the rated voltage...but the problem is that I dont find any good battery source which is compact and operating at...
l298 unipolar
Hello friends..
I am using atmega32 to drive two unipolar stepper motors (5 wired) rated at 12V,~1A
I had been using ULN2803 to drive these stepper motors...
I face a strange problem....
1.The ULN gets heated very quickly.
2.I get varied results every time i power up the circuit...
unipolar stepper driver schematic
Hello friends..
I am using atmega32 to drive two unipolar stepper motors (5 wired) rated at 12V,~1A
I had been using ULN2803 to drive these stepper motors...
I face a strange problem....
1.The ULN gets heated very quickly.
2.I get varied results...
Windows PowerShell
Microsoft Windows PowerShell command line shell and scripting language helps IT professionals achieve greater control and productivity. Using a new admin-focused scripting language, more than 130 standard command line tools, and consistent syntax and utilities, Windows...
Check the receiving signal on an oscilloscope...if the signal is weak i guess u need to amplify it...
i hope this link comes u good
...http://www.massmind.org/images/www/hobby_elec/e_sonic1_3.htm
testing a stepper motor with battery
I have wired them properly....when connected them to the controller the applies Vcc to centre taps and when tested it using a 12V battery I had them open circuit and connected the two phases to the source one by one...thee connections are right i guess...
testing of stepper by battery
Hello friends...
I need some help from u guys...I am working on a project that drives UNIPOLAR STEPPER MOTORS(6 wire)...the motor is rated at 24V and i am driving it using ULN2803 which gives a logic 1 of around 5V....the problem is the motor locks at all...
m32def.inc
I had written a basic program to STORE data in SRAM and compiled it with the data memory window open. The result was as expected. The data from a register was STORED into the SRAM location. The program was as below....
;Program to store data into SRAM location 0x60
.include...
hi friends.....
Im building an energy meter based on AD7751....i thought of using 8051 for processing the energy data...but i've read a few post based on my proj....i found ppl generally do not prefer 8051 as MCU...wats the reason???....>>>ad7751 is SPI compatible ...isin't it???
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
