Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
If you want to interface with large size NAND Falashs It is preferable to use MMC/SD memory cards the following application note describes the interface of MMC/SD memory cards to the msp430 via the SPI bus
www.focus.ti.com/lit/an/slaa281a/slaa281a.pdf
labview usb driver
Dear Soundar
Thank you for your reply. I want to use the USB to printer port interface on register level not as printing device. Now when the device is plugged to the computer the operating system recognise it as "USB support printing" I want the operating system to...
LabVIEW and XILINX
I think you must use a dual port RAM between the FPGA and the processor under test to write and read instructions and data to the processor under test The FPGA can only monitor the address bus, data bus and control bus of the processor under test
LabVIEW and XILINX
I think it is possible to use the Labview FPGA module from Natinal Instrument. But what type of the test you are going to do with the 8085 or 8086
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
