Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi jayanth,
I did the same but the Led will be On for 100 ms only and will be OFF again , i think you did not get my point and i will be more clear . when i power the Circuit the LED should be Off then if i pressed the Push button the LED should be ON and keeps ON even if i released the button...
Guys, I want if i pressed the button in RA0 to make the led on PortB.F7 to light up till next press . so even if i released the button the led should be on till next press any hep on this please .
Hi Guys , I have below code from Arduino and need help to change it to MikroC . the reason of this just to see how is MikroC will be changed the Function code .. i am going to use 16f877 with Osc 10 Mhz , using any port setup no issue for me , i will modify it later on . The code is...
I am using 16f877
Mikro C .
i sued similar to the code in https://embedded-lab.com/blog/?p=1443 but i changed to be for one button but was not working then i tried to use the MikroC Buttons library and i got same issue . the above example has tow buttons but i want to control the Led by...
Guys , i really need urgent help regarding push buttons .
i connected one button to RA0 and Led to PWM1 and i tried to increase the brightness and decrease it by one button , the problem is i can not keep the status of the led and the button , if increase it to 64 and released the button,, the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
