Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello!
I am trying to get AT89s52 to read 4 bits coming from decoder(HT12D)
the bits are read on the AT89s52 from P3.2-->P3.5
I tested and the bits arrive correctly to the decoder.
ALso, the at89s52 is interfaced with lcd 16x2. I tried reading then masking it with no use. Sometimes I get...
I tried all speeds still same error
---------- Post added at 07:13 ---------- Previous post was at 07:12 ----------
I tried all speeds still same error
Thnx for your help but I setup the circuit as shown above. But when I try to erase/program at89s52 I get this screen
use follow connection with the avr isp.
any help?=/
Thanx
transistor bc557 == the voltage regulator 7805?
---------- Post added at 14:39 ---------- Previous post was at 14:05 ----------
Also all I got is crystal 11.059 MHZ is that ok?
Hello. I am using RAM Electronics : ATMEL AVR ISP Programmer "AVR AVRISP V2.0 STK500 USB ISP" [AVR.Programm] - 160.00L.E. to program an at89s52. I am totally new at this. So I wanted to figure out what should I connect to the at89s52 to program it?resistances?vcc? do I use the at89s52 clock? I...
I dunno if it's been asked before but what are the values of resistances and capcitors needed for at89s52 and ht12e/ht12d rf encoder/decoder?
and is there a tutorial showing how to program and/or connect at89s52 with isp programmer(hardware connections)
Thanks =)
Thanks for reply, I just have couple of questions on rx what is the 2003 IC
secondly would it work with the tx433 and rx433 , likke the ones in this article Running TX433 and RX433 RF modules with AVR microcontrollers | WinAVR AVR-GCC Tutorial
thanks for ur help =)
I couldn't find the tx rx u mentioned, is there anyway to do it through software , like this project Running TX433 and RX433 RF modules with AVR microcontrollers | WinAVR AVR-GCC Tutorial , and if I have to use the encoder/decoder ht12e and ht12d what would be modified in code?
Thanks for ur...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.