Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
I am studying on RWG Function. I used Makarov's book and codes. However, his code does not work for small object. For example when the square plate in 0.15 lambda, it does not match with RWG's original paper's results. I need codes that is based on RWG's original paper. Could you share an...
Hi, I have designed a quad ridged horn antenna. Everything is fine, gain, sparameters, etc. However, E-plane pattern of each port has shifted 1-2 degrees. It is because of the asymmetry of quad ridged waveguide feed section. This is caused by the phase delay due to other prob's enterance. When...
S11 is obviously 0 dB. There might occur some computational error caused by computer (Not yours, in general). If you attach the gain plot, someone can comment on result.
Your design has given me an idea. I would use it to combine 2 linear ortogonally polarized double ridged waveguides into a quad ridged one. However, I can change it so that the amplifier works as its input and output is the same quadruple ridged waveguide. Can I do it? Is it possible?
But the problem is that: This Quad Ridge WG will be used for high power application and the frequency is high. There is no connector that can handle the power according to connector manufacturers. Therefore, I need to get the signal from amplifier which has double ridge waveguide end and then...
Hi, I need to design double ridge to quad ridge transition. But, I have 2 double ridges, which are used for double polarization in quad ridge waveguide. How can I achieve transition?
Hi
I want to simulate n-type connector, which is given in manufacturer web-site:
https://mpd.southwestmicrowave.com/products/family.php?family=155
I will use it for feeding my antenna. I think I should use jack part.
Which values should I use for inner and outer conducter diameter?
Thanks.
Hi,
I want to design a quad-ridged waveguide. I also need transition, a coaxial feed. How should I choose the waveguide parameters and feeder in order to satisfy power handling?
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
