Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
buck boost chopper
hi all,
now i would like to build a buck-boost chopper which have variable output.
after i done my connection as shown in the figure, i found that 0V at my output..
no matter how i adjust the frequency fed in, the output is still 0V.
then i go to do some researches, i...
hi~cyr
yah...like u said...
i should write with that only...
no need to check 1 by 1...
thus, i didn't set my portb as input also...all my setting is wrong...
i corrected it already and everything works fine...
thanks a lot!!
hello all,
i'm new in microcontroller...
Recently,i would like to do a project regarding the used of PIC16F877.
So,i test my PIC's i/o first..all the output pins of my PIC can work well.(i test with led blinking program..
but when i test the input pins of porta and portb with the program at the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.