Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Does anyone have example atmega8 c code for sht11 sensor. I looked datasheet and sample code provided on the web, but still have problem with problem with reading and sending command to sht11. Anyone can help. Thank you
How to buld a switch regulator, instead of using IC with input of 15v to 60v dc convert to 5vol dc? I need this regulator as power supply for mirco-controller- atmega8.
hi Keith,
Thanks a lot, it really helped. But during simulating, even the source is produce 13v, and the circuit since not working. Is that because we were asked to use BC547B for transistor and 1N4148 for diode?
Ben
The project we are asked to deliver is to build a liner voltage regulator without opamp, only use transistors, diodes, and zener diodes. The input is a sine wave with peak values as 7 to 13v,and output is lower than 5v. how to build this regulator?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
