Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
automatic port zeland
As it was mentioned earlier probe feed and vertical polarized are ports of the same type:
REF: ie3d_manual, App. I, p.10, quote: "Probe-Feed to Patch: It is an automatic way to build a Vertical Localized port."
My questions are still valid: Does it mean that in IE3D the...
ie3d port
Hi Guys,
Thanks go to balaguru thavamani for pointing out that vertical localized ports should be used instead of differential advanced extension. Much appreciated.
Went through most of the manual, no mentioning of different port conflicts found. Does it mean that in IE3D the ports...
port connection in ie3d
Hi jian,
Thank you for your suggestions. I have actually tried to use Zeland's original sample file: "meander4.geo" where ground plane supposed to be well defined. Even with this file the probe-feed to patch can not be added and the following error message comes up...
ie3d ver 11 probe-feed to patch
Hi balaguru thavamani,
Thank you for your response.
Well, it is actually not a dual-feed,.I am loading the antenna with a capacitor. In order to do that, as it's suggested in the manual, I have to EM simulate the structure with two ports and then in MODUA I...
balaguru thavamani
Hi,
I am trying to set up a problem in IE3D where there is an edge-fed loaded patch antenna. The problem is this: after setting up advanced extension differential port on the microstrip I would like to insert a probe feed to patch, however the program gives me an error...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.