Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I want to design a vco at 2.5GHz in 90nm.
I have to simulator tt 25 degree but the corners(ff 0 degree in vdd+10% and ss 100 degree in vdd-10%) was fail.
Delay cell in vco was symmetrical load.
How can i improve it?
Regards
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
