Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I'm using the optocoupler HCNR200 and I need to know how I can to use it for measurement 220 VAC, because I'm probing the circuit dual with two LM158 and two HCNR200, but the circuit not working.
(The circuit that I use is of the figure 3 of the application note 1357 of Agilent...
Hi:
I need to know if I can to connect two triacs like I show in this schematic, and I need to know if the location of the Ground (1 and 2) is correct for my application.
I triggered one of them (the triacs with ground 1) without the other (closing the circuit in ground 0) and I dont have...
ups problem
Hi.
I try to desing a UPS with UPQC topology for non-lineal load, genering a signal with dsPIC30F4011 with modulation PWM in 40kHz, but i have a big problem with noise in output signal in my inverter mosfet when I connect my low pass filter.
My low pass filter is in output of my...
To use IGBTs, we need to know the power of your system, and you have to do that voltage and current that supports the IGBT, which is delivered to your system.
So, you should know that IGBTs need a special circuit for qeu suits the voltage levels of the shoot which requires the IGBT. this circuit...
Hi.
I upload a video of the invent "windbelt", by Shawn Frayne.
The windbelt is a new invent, that leverages the strength wind to generate electricity
I hope you enjoy it.
pickt2 firmware
Vary thank guy for your work, and congratulations. But i have a question: ¿someone have a .hex with program a 18F2550??. I dont have this code. and for I make this project, I need the code.
If someone can give me a code, very thank.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
