Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am new to Pads Logic, when I tried to add the ground symbol, I always get the warning message stating that “Part selected is an off-page and not a component. I notice that when I right click on the existing ground symbol of the sample schematic circuit, there is no option to copy the ground...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
