Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi there!
I want to use the KAF1001-CCD for image processing (https://www.onsemi.com/pub_link/Collateral/KAF-1001-D.PDF).
I have some understanding problems with the clocking/timing of V1 and V2 according to set the integration time.
In the datasheet on Page4 it is written:
"Referring to the...
Dear forum,
just a simple (?) beginner question:
What is the difference e.g. having a differential opamp circuit with v=10 and using
1) 10k-resistor and 100k-resistor (OPAMP_1.png)
OR
2) 1k-resistors and 10k-resistor (OPAMP_2.png)
Thanks so far!
Sorry but what exactly do you mean with "common mode impedance"?
Another question: I also have to transmit a 160MHz single ended clock from the FPGA via the same cable to the sensor.
The setting is as follows:
FPGA => 3 cm to connector => 20cm cable => 3cm to clock dirver => 3cm to receiver...
Hi there,
I'm using a sensor with 16 LVDS pairs @160MHz. I have to transmit this data to an FPGA (Altera) via a 20cm cable. In the past I was using a 100-Ohm diffential high speed cable from Samtec:
https://www.samtec.com/technical-specifications/Default.aspx?SeriesMaster=EQDP
Now I need...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
